We do not recommend placing in the fridge with foodġ0) Allow ZYREX to dry to touch – Between 2-36 hours depending on temperature, the cooler the air the longer you can go between coats if needed.ġ1) Repeat steps 6-10 until you get 4 complete coats on the boat. If you mix more than needed cover & place in the fridge or cooler with ice, if sealed it can be used for up to 24 hours. You will want to mix what you think you will use for each coat or one or two quarts at a time. You don’t want to see any shiny areas.ħ) Mix per instructions on the can. IF YOU HAVE AN ABLATIVE PAINT IT MUST BE SANDED THOROUGHLY FOR ADHESION.ģ) Tape off at waterline or customers may prefer to do the bottom only from edge to edge.Ĥ) Sand with 40 or 80 grit sandpaper to remove the shine of gel coat. UASED FIBERGLASS BOATS WITH OR WITHOUT PAINTĢ) ALL BOTTOM PAINT MUST BE SANDED, SODA BLASTED OR SANDBLASTED OFF. Make sure heat source is 18” to 24” away from the surface.ġ5) Allow the boat to sit for at least 3 days before splashing in the water. You can carefully heat up areas with a heat gun or a heat lamp to speed dry.
Blue, Green, and White are a little more translucent so you will need a 5 th coat for even coverage.ġ3) Move jack stands or straps to previously coated areasġ4) ZYREX other areas. Remove all tape, if left on will become hard and difficult to remove.ġ0) Allow ZYREX to dry to touch – Between 2-24 hours depending on temperature and humidity, the cooler the air the longer you can go between coats if needed.ġ1) Repeat steps 6-10 until you get 4 complete coats on the boat. If you notice a run-roll lightly to remove. All coats must go on very thin.ĩ) Apply one coat of ZYREX, it should be thin so as not to run or ripple. In addition, more material is lost in the air due to atomization. Spraying wastes much more material, it must be sprayed on in a mist such as spraying PVA on a mold which leads to applying double the amount of coats. WE DO NOT RECOMMEND PLACING IN FRIDGE WITH FOOD.Ĩ) We recommend using a short ¼” nap roller. If you mix more than needed cover and place in the fridge or cold area even a cooler with ice would work, if sealed it can be used for up to 24 hours. Always clean mixing blade with Acetone after mixing each can.ħ) Mix per instructions on the can. After pouring A and B together with a mix for 5 additional minutes to completely blend. You don’t want to see any shiny areas.Ħ) Mix A and B separately in their respective cans with a drill and mixing blade for 3-5 minutes. NEVER USE PAINT THINNER OR MINERAL SPIRITS IN ANY PART OF THE ZYREX PROCESS IT WILL NOT WORKġ) Wipe entire bottom with acetone alternating white rags to remove mold waxesĢ) Tape off at waterline or customers may prefer to do the bottom only from edge to edge.ģ) Sand with 40 or 80 grit sandpaper to remove the shine of the gel coat. *USE SPERATE MIXING PADDLES FOR EACH PART
*NOT MIXING CONTENTS THOROUGHLY OR FAILURE TO APPLY RECOMMENDED NUMBER OF COATS MAY CAUSE A UNSATISFACTORY RESULTS AND PERFORMANCE Preparation is important! Below you will find the steps needed to ensure a good bottom paint job with Zyrex. Applying bottom paint is really simple to do.
0 kommentar(er)
